Summary
The main components of the product are poly-alpha olefin polymer powder and mixed alcohol ether suspension. Easy to store and use.
Drag reducer is used in long distance pipeline, suitable for crude oil and product pipeline, and polymer produced by special process. Suitable for pipelines with small injection volume, obvious transportation effect, closer storage environment to extreme environment, and products more suitable for cold areas. Generally, the injection concentration is less than 10 ppm. By adding a small amount of drag reducing agent (ppm level) to the pipeline, the physical effect can be eliminated, the turbulence of high-speed fluid can be eliminated, and the drag of delay can be reduced. Finally, the purpose of increasing pipeline transportation capacity and reducing pipeline operation pressure can be achieved. The performance of drag reducing agent is greatly affected by the pipeline working conditions. The increase rate of drag reducing agent tested by the manufacturer only represents the data of the drag reducing agent on the manufacturer's experimental pipeline. The actual value should be based on the local test data.
Technical data
|
Test items |
Executive standard |
Technical parameters of products |
|
Form |
Visual measurement |
White liquid |
|
colour |
Visual measurement |
White |
|
smell |
―――――― |
A slight hydrocarbon odor. |
|
Solubility |
―――――― |
Insoluble in water, soluble in hydrocarbon solvents and oils |
|
sampling |
GB/T 6680 |
300 ml test; 300 ml sample preparation |
|
density |
GB/T 4472 |
0.85-0.9g/cm³ |
|
Flash Point (Closed) ℃ |
ATSM D7094 |
＞62 |
|
PH value |
PH test paper |
6-8 |
|
Kinematic viscosity （20°C，mPa.s,20s-1） |
SY/T 0520 |
＜500 |
|
Polymer content（％） |
―――――― |
20-40 |
|
Rate of increase |
SY/T 6578 |
＞30 |
|
Pour point（℃） |
GB/T 3535 2006 |
≤-45 |
Note: The above data only represent the parameters of HJ-E400H drag reducer. The technical parameters of different types of drag reducer will be slightly different.
Application method
The product itself can be used in most long-distance pipelines. Users need to provide specific parameters of pipelines to manufacturers for simple calculation.
Drag reducer is injected into the pipeline quantitatively through plunger pump, and the injection point should be chosen at the back end of the oil pump and as close as possible to the exit end. For multi-pipeline, the injection point should be selected at the back end of the pipeline junction. In this way, drag reducer can play its performance well.
Package
Packed in IBC container barrel, 1000L/barrel. Or based on customers’ request.
